Switching

We have  the following IP's assigned to the VLAN interfaces interface Vlan100ip address 172.30.168.2 255.255.255.0(Range will be 172.30.168.0 - 172.30.168.255)interface Vlan200ip address 172.30.169.2 255.255.255.128(Range will be 172.30.169.0 - 172.3...

Hi, I have configured the setup mentioned in following drawing with Cisco 3650 core switch and two Cisco 2960 access switches. After configuring ip route 0.0.0.0 0.0.0.0 192.168.30.254 on core switch, vlan 30 is able to access internet while other vl...

How do I set an interface on a Switch to default in Cisco packet Tracer.I tried the #default interface <Interface Name> command, it does not work.Tried placing "no" keyword before the command, but it is quite hectic process if we have a long list of ...

Dear All, i got catalyst 9200 L Layer 2 Switch and gave the power to boot up. at privilege level 1 i gave the command ENABLE from privilege 1 to come in privilege 15, As a result it requires password 3 times to log in. As default password for switch ...

We have 2 core cisco Nexus 9K switches and I noticed that one is the STP root for vlans while the other is the active HSRP gateway for vlans. I'm pretty confident that the primary switch should be both the HSRP gateway and the root--correct me if I'm...

Hi, From the manual i can see this switch allows POE - Power Over Ethernet.I'm trying to power an Wireless Access Point.I would like to set POE onto port 13. I have set port 13 to a delicated VLAN for Wireless Access Point. What's the command or how ...

Hello, I am going to replace my core which is 6509 with 9400 switch. But we have wireless controller on 6509 which I still want to use for sometime. So if I remove routing from 6509 and make a access switch would wireless controllers still work? Than...

Hi, I have a 4507 with dual sups 6-E. The chassis is configured for SSO. I upgraded from 15.2(2)E5 to 15.2(2)E8 by doing the following:1-Loaded the new IOS in the bootflash & slavebootflash2-Edited the boot system so it's pointing to the new IOS3-Iss...

Hi,is there any way to assign 2 IPs to an interface of 9300.i am running IOS XE 16.09.04 and sub-interface is not supported on this platform.

hello, my question is as follows, with this range of switch "Sg350 xg-24 f-k9-eu" to limit the speed of ports from 10 Gb to 1 Gb with SFP GLC-T for the connect to switches that support only 1GB

Hello All, I have the below configs on my ADSL VPN router where i run an IPSEC tunnel to may corporate Palo firewall to establish the VPN connection. VPn ADSL Cisco 877 Router--> internet--> Palo Firewall (where IPSec VPn terminated)--> Core switch--...