12-20-2012 10:04 AM - edited 03-07-2019 10:43 AM
It was recommended by a cisco reseller to failover the supervisor modules every so often to ensure redundancy but i can't find the documentation that supports this nor anyone else doing it.
12-20-2012 11:00 AM
Sup redundancy and fail over testing should be done during the testing phase of the equipment and/or after major IOS upgrade to make sure it actually works. Once it has been determined that it works with no issue, there is no need to do it every so often.
HTH
12-20-2012 11:27 AM
Hi netsquant,
You dont failover them unless you are testing the same in a scheduled test case scenario.
You can check the status regularly using the gold feature general online diagnostics feature however as a best practise.
Rgds/dp
Pls rate helpful posts.
Sent from Cisco Technical Support Android App
12-20-2012 01:45 PM
"hw-module module
If you want to test the redundancy, then the command "redundancy force-switchover" could be what you are looking for.
02-25-2013 06:24 PM
Thank you
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: