11-15-2018 06:51 AM - edited 03-08-2019 04:37 PM
Hi ,
I have cisco 892 router running with c890-universalk9_npe-mz.155-3.M8.bin ios where we are observing the below errors.
%BGP-5-ADJCHANGE: neighbor xx.xx.xx.xx Up
%BFDFSM-6-BFD_SESS_UP: BFD-SYSLOG: BFD session ld:1 handle:1 is going UP
%BGP-3-NOTIFICATION: received from neighbor xx.xx.xx.xx 4/0 (hold time expired) 0 bytes
%BGP-5-NBR_RESET: Neighbor xx.xx.xx.xx reset (BGP Notification received)
%BFDFSM-6-BFD_SESS_DOWN: BFD-SYSLOG: BFD session ld:1 handle:1,is going Down Reason: RX ADMINDOWN
%BGP-5-ADJCHANGE: neighbor xx.xx.xx.xx Down BGP Notification received
%BGP_SESSION-5-ADJCHANGE: neighbor xx.xx.xx.xx IPv4 Unicast topology base removed from session BGP Notification received
%BFD-6-BFD_SESS_DESTROYED: BFD-SYSLOG: bfd_session_destroyed, ld:1 neigh proc:BGP, handle:1 act
%BFD-6-BFD_SESS_CREATED: BFD-SYSLOG: bfd_session_created, neigh 10.80.32.129 proc:BGP, idb:GigabitEthernet
Remote end Alcatel Router is connected , both side the conf is looking fine.can any one help to resolve the same.
11-15-2018 07:16 AM
11-15-2018 09:27 PM
Not configured.
11-15-2018 10:57 PM
11-15-2018 10:10 AM
Hi,
Is BFD enabled on this interface? If yes, you may want to remove it and test again or check to make sure that both sides of the connection match.
HTH
11-19-2018 02:12 AM - edited 11-26-2018 10:49 PM
Hi Team,
As per cisco document because of this accelerated handling of BFD control packets, all output features are bypassed. Users cannot, for example, filter or apply Quality of Service (QoS) to transmitted BFD packets.
Is there any posibility to filter or apply Quality of Service (QoS) to received BFD packets.
Kindly help me to know the same if possible share cisco doc as well
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide