We are switching to template configuration but have run into an issue.
Sample template on IOS XE 03.16.09:
router bgp 1
template peer-policy ROUTE-REFLECTOR
After setting up each neighbor (about 80 neighbors) with the inherit peer-policy ROUTE-REFLECTOR the template end result is each neighbor is then configured with send-community extended. I'm able to then modify each neighbor statement with send-community both but was hoping the template solution would function more consistently for all options. If I remove the send-community both from each neighbor statement, the template reverts back to send-community extended per neighbor.
Purpose of the documentReference TopologyUse-CaseSymptomDiagnosisSolutionAdditional References
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The ...
Dear All, When I use the show interface command on the Cisco Router ISR-4331, it will display as below information. The word that I mark red, it refresh every 5 seconds. But, I compare with the old router model like a Cisco 29XX or 28X...
Whether you're attending VMworld 2019 on-site or from afar, read the latest on the key themes to expect. They are also the key themes for IT management today, from software defined everything to cloud and automation to IoT and edgecomputing : http:...
To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about SD-WAN), it's foundations and inner mechanisms as well as its correct design a...