Hello,
I am trying to find out the proper IOS command on a 3750 or a 4948 (if possible) to do bridge multicast filtering. The group I am supporting previously did this on a Dell Powerconnect 3324.
The dell configuration looks something like this:
*Example*
int vlan 50
bridge multicast address 0100.5e40.000a add ethernet 1/e5
On the Dell you would continue adding any additional MAC addresses that you have and point them to specific ports you want them to go.
Essentially I need to know how to make the above, happen on the above Cisco devices.
I've spent a good part of the day trying to look through Switch Configuration documents and looking at the physical switch being used, and haven't seen anything that looks close.
Thanks for any assistance,
Matt