hello,
I want to connect two switches of 6500.
I want to use in int vlan, I assign the port (tengig) to vlan 55. (Drawing)
the commands:
6500A:
int tengig1/1
switchport access vlan 55
int vlan 55
ip address 1.1.1.1 255.255 255.252
6500B:
int tengig1/1
switchport access vlan 55
int vlan 55
ip address 1.1.1.2 255.255 255.252
When I do "show int vlan 55" so I accept "BW 1000000 Kbit" , I spend 9Gig.
Why the BW of vlan 55 is 1G and not 10Gig?
I lose 9Gig (Bottleneck)?
Am I wasting bandwidth with this method?
In addition, I performed an experiment that I added to vlan 55 more tengig port and the BW of vlan 55 stay 1Gig.