cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
567
Views
0
Helpful
2
Replies
Zeljko Milinovic
Beginner

C4500 - High CPU - Supervisor II-PLUS-10GE - IOS 12.2(31r)SG3

We have two c4500 with above characteristics.

The cpu usage is even more higher when I apply a voice ACL on the on of the switches, more than other.

The peak is at Lopri processes.

I attached the show procc cpu and sh platform health.

When I apply a ACL the cpu utilization is 90%.

In my show log I have detected only one error duplex mismatch. The network is operating normally now, but I disabled the ACL on the other switch because than the CPU spikes. The same ACL is working fine on the other switch.

Thanks in advance.                  

2 REPLIES 2
Zeljko Milinovic
Beginner

I have attached another show cpu and platform output with the 70% usage. The ACL is not active, but still big usage.

The process is K2CpuMan Review and K2AccelPacketMan: Tx are using more then used to.

The proccess K2CpuMan has greatly devolved to a normal stage when I typed in the comand:

no ip unreachables on voice vlan interface

I am reading now on what are the side effects of this command.

This command stopped sending back to the cpu ICMP packets for the denied packets in the ACL.

That used a lot of cpu utilization.

Any suggestion is much appreaciated.