cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
123
Views
0
Helpful
1
Replies
Highlighted
Beginner

C6K Active Supervisor election

Hi everyone

I have WS-C6509-E chassis with 2x WS-SUP720-3B in slots #5 and #6. when i power up the chassis i expect to sup in slot #5 became active and slot #6 be Hot status (Operating Redundancy Mode = sso). But when i check the supervisor engine i see something else.

Mod    Card Type                                      Model
---     --------------------------------------       --------------

5        Supervisor Engine 720 (Hot)     WS-SUP720-3B
6        Supervisor Engine 720 (Active) WS-SUP720-3B

As far as i know active Supervisor election should be based on slot boot sequence. Slot #5 will boot first and should elect as active supervisor.

The only different i see is :

Mod Hw      Fw                Sw             Status
-----   ----------- -------------- -------------------------
5      5.7     8.4(2)      12.2(33)SXI6      Ok
6      5.9     8.5(3)      12.2(33)SXI6      Ok

Any idea on this case?

Thanks for your time.

1 REPLY 1
Highlighted
Beginner

Any help would be appreciate.

Thanks

Content for Community-Ad