C887VA-W-E-K9 AP 802 AUTONOMOUS HOSTNAME DNS RESOLVE ISSUE

[Sebastian Sajak]

Hello:). Please help me because I was stuck on the configuration of the AP.

Clients connected wired can connect to the host (Matrix_Storage) via the IP address and hostname but clients connected wirelessly can connect to a host (Matrix_Storage) only by entering its IP address. 

What is wrong? Where did I make a mistake? 

In the attached configurations of the AP and the Router. 

Regards, Seba.

[Richard Bradfield]

I am interested to know how the clients get their IP addresses, as in your DHCP config, all addresses are excluded on the 192.168.1.0/28 network except 192.168.1.10 which gets assigned to the router. or is the IP addressing of clients done via theradius server.

regards

Richard.

[Sebastian Sajak]

I fixed configuration but still no change :(

[johnd2310]

Hi,

What device is using 192.168.1.1  and what is your internal dns/wins server?

Thanks

John

[Sebastian Sajak]

192.168.1.1 - it's address of router C887VA-W-E-K9

my internal server address - 192.168.1.1

[johnd2310]

Hi,

Set up your internal server to do dns and set wired and wireless clients to use it as dns server. 

Configure required resources on the dns server

Thanks

John