Hello, Here is the information.
For now, I moved AP connection to other switch, cause AP doesn't work due to medium power.
sh int gi1/0/21, 22
GigabitEthernet1/0/21 is down, line protocol is down (notconnect)
Hardware is Gigabit Ethernet, address is 74ad.98fe.8d95 (bia 74ad.98fe.8d95)
Description: MCA_2802E_AP_13
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, Auto-speed, media type is 10/100/1000BaseTX
input flow-control is on, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 18:06:21, output 18:06:21, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
7380185 packets input, 1571045812 bytes, 0 no buffer
Received 4419868 broadcasts (4417807 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 4417807 multicast, 0 pause input
0 input packets with dribble condition detected
31170059 packets output, 2924063985 bytes, 0 underruns
Output 10863550 broadcasts (0 multicasts)
0 output errors, 0 collisions, 10 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
MCA-Sec-C1#sh int gi1/0/22
GigabitEthernet1/0/22 is down, line protocol is down (notconnect)
Hardware is Gigabit Ethernet, address is 74ad.98fe.8d96 (bia 74ad.98fe.8d96)
Description: MCA_2802E_AP_14
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, Auto-speed, media type is 10/100/1000BaseTX
input flow-control is on, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 18:05:52, output 18:05:51, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
7376333 packets input, 1570531670 bytes, 0 no buffer
Received 4419627 broadcasts (4417617 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 4417617 multicast, 0 pause input
0 input packets with dribble condition detected
31167411 packets output, 2923680169 bytes, 0 underruns
Output 10863845 broadcasts (0 multicasts)
0 output errors, 0 collisions, 9 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
and the sh run int gi1/0/21-22 :
interface GigabitEthernet1/0/21
description MCA_2802E_AP_13
switchport access vlan 15
switchport mode access
power inline port priority high
power inline static
duplex full
no cdp enable
end
MCA-Sec-C1#sh run int gi1/0/22
Building configuration...
Current configuration : 228 bytes
!
interface GigabitEthernet1/0/22
description MCA_2802E_AP_14
switchport access vlan 15
switchport mode access
power inline port priority high
power inline port 2x-mode
power inline static
duplex full
no cdp enable
end
For your information, I put power inline 2x-mode and priority high to provide maximum power. (Not 15.4W).
I did whatever I can..
Thank you so much Mr.Pessoa.
