cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
288
Views
1
Helpful
3
Replies

C9200 48 p Switch Boot error

Junak
Level 1
Level 1

when switch was restart and below log.....Please help any one about this issue...............

switch: reset

Are you sure you want to reset the system (y/n)? y
Please wait while the system restarts.

Initializing Hardware...

System Bootstrap, Version 17.8.1r [FC5], RELEASE SOFTWARE (P)
Compiled Wed 01/12/2022 17:11:24 by rel

Current ROMMON image : Primary
C9200-48P platform with 4194304 Kbytes of main memory

switch:

 

 

 

3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame

If the switch is still in ROMMON, post the complete output to the following commands: 

set
dir flash:

Enes Simnica
Level 1
Level 1

Hello @Junak 

Your Catalyst 9200 switch is stuck in ROMMON mode after a reboot, and this can fix it:

  1. Check Flash Content:
    Run dir flash: to see if the IOS image is present.

  2. Set Boot Variable:
    If the image is there, set the boot variable:

    switch: BOOT=flash:/<your_image.bin>
  3. Manually Boot:
    Boot the switch with: switch: boot

     

If the IOS image is missing or corrupt, you'll need to re-upload it.

E.S

more Cisco?!
more Gym?!


@Enes Simnica wrote:
  1. Set Boot Variable:
    If the image is there, set the boot variable:

    switch: BOOT=flash:/<your_image.bin>

This response proves even ChatGPT gets it wrong.  

Review Cisco Networking for a $25 gift card