01-07-2022 05:41 AM
we have core switches with PID : C9500-24Y4C and the current version is 17.03.04 , PID: C9200-24P with module C9200-NM-4X and the current version of C9200 is 17.03.04b
once I connect the uplink between the C9500 & C9200 using the 10G-SR the C9200 is not reachabe and not appearing at show cdp neighbor, the link is up & working fine on 1G
Note : I tested with another switches & fiber and it's same status
01-07-2022 05:46 AM
Use a different firmware on the 9200/9200L.
01-07-2022 06:08 AM
try nonegotiation command on the interface config.
also post show interface x/x show run interface x/x from both the ends.
01-11-2022 11:40 AM
I had exactly the same issue with the same products.
Had to downgrade to 16.12 to fix this.
Seems to be a compatibility issue between NM-4X & IOS-XE 17.4.3 on the 9200 platform.
01-11-2022 12:11 PM
Open TAC case to investigate for you, since i do not have that version to test for you, 17.3.3 works as expected.
01-12-2022 06:43 AM
Is the downgrading solving the issue
01-12-2022 07:19 AM
sure if that works for you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: