cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
302
Views
0
Helpful
2
Replies
Highlighted
Enthusiast

C9300 & Spanning-Tree Link-Types

Hello,

 

I am working on replacing a couple of C6504 switches with C9300s. The IOS version on the new C9300 is: Cisco IOS XE Software, Version 16.06.03. I noticed that when I tried to configure some of the ports with
spanning-tree portfast edge, the "edge" parameter is not available. It seems that with IOS XE ver 16.06.03, the edge, network, and normal link types are no longer supported.  I was wondering if anyone else has run into a similar situation! Also, I couldn't find any Cisco documentations to show to configure the spanning-tree on ports? 

 

Thanks in advance, ~zK

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Collaborator

Hello,

"spanning-tree portfast" and "spanning-tre portfast edge" has the same functionality. Some versions had the as only "portfast" and an others "portfast edge"

Regards,
Jaderson Pessoa
*** Rate All Helpful Responses ***

View solution in original post

2 REPLIES 2
Highlighted
VIP Collaborator

Hello,

"spanning-tree portfast" and "spanning-tre portfast edge" has the same functionality. Some versions had the as only "portfast" and an others "portfast edge"

Regards,
Jaderson Pessoa
*** Rate All Helpful Responses ***

View solution in original post

Highlighted

Got it!

 

Thanks, Jaderson.

 

 

Best, ~zK

Content for Community-Ad