cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
191713
Views
52
Helpful
19
Replies

C9300 switch reset to factory

NetAdminMBC
Level 1
Level 1

So, got a brand-spankin' new Catalyst 9300.  Racked it up, connected to console port with PuTTY, booted the switch.  Went through the basic configuration script.  When it was done, I tried to enter enable mode and found I couldn't - evidently, I fat-fingered the password. 

I don't care about the config that's on there now- it's easily re-creatable.  I'd like to erase the startup config and start over, but I can't seem to get there.  Is there a procedure document somewhere that will tell me?  I vaguely remember, with older switches, breaking into the power up routines and erasing the config from flash.  Is that still possible?

 

19 Replies 19

Reza Sharifi
Hall of Fame
Hall of Fame