cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
505
Views
0
Helpful
1
Replies

C9800-40 redundancy issue

CCC3
Level 1
Level 1

Two C9800-40
I'm trying to redundancy.

If the port on the switch to which the active unit is connected is shut down, it is normal for a failover to occur and a standby to occur.

But it goes into the removed state as if the rp was cut off and stops working altogether.

Of course, the ping doesn't go out either.

Are there any bugs?

If not, what's the problem?

Settings are fine.

1 Reply 1

balaji.bandi
Hall of Fame
Hall of Fame

how is your RP and SP port connected ? back to back or using any Layer 2 switch ?

what code runnning to see any bugs around that behaviour, not that i am aware

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: