11-16-2022 11:54 PM
What does the statement below in the Limitations and Restrictions section of the release notes for Cisco Catalyst 1000 Series Switches mean?
Multi-chassis EtherChannel (MEC) is not supported.
Since the C1000 device supports PAgP or LACP, I think it can connect to VSS or StackWise as MEC.
Does this phrase mean that I cannot connect C1000 devices to VSS systems or StackWise Virtual systems?
11-17-2022 02:30 AM
No, Catalyst 1000 only supports "horizontal stacking".
11-17-2022 04:15 AM
you cannot connect C1000 switches in VSS. you can connect uplinks and downlinks using LACP or PAgP to increase bandwidth between switches.
11-17-2022 05:25 PM
Thank you for your answer.
The intent of my question is not to make the C1000 switch a member of the VSS system.
As shown in the attached picture, is it possible to uplink the C1000 switch to the currently configured VSS system to MEC?
I tested connecting to the VSS system through MEC using the UTP port of the C1000 switch, and it was connected normally. I would like to know if this connection method is the normal way.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide