cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
19840
Views
15
Helpful
8
Replies

Can I remove "call-home" setting on Cat6500?

snakayama
Level 3
Level 3

Hello everyone,

I want to remove the following "call-home" setting from configuration (NVRAM) or stop it from showing by show runn command on Cat6500 12.2(33)SXH4.

Is it possible or I can't remove it?

If possible, could you please let me know how can do it.

=====

call-home

alert-group configuration

alert-group diagnostic

alert-group environment

alert-group inventory

alert-group syslog

profile "CiscoTAC-1"

no active

no destination transport-method http

destination transport-method email

destination address email callhome@cisco.com

destination address http https://tools.cisco.com/its/service/oddce/services/DDCEService

subscribe-to-alert-group diagnostic severity minor

subscribe-to-alert-group environment severity minor

subscribe-to-alert-group syslog severity major pattern ".*"

subscribe-to-alert-group configuration periodic monthly 26 14:24

subscribe-to-alert-group inventory periodic monthly 26 14:09

=====

I understand the default setting of Call Home feature is disabled, but I want to remove it.

Thanks and regards,

Shinichi

1 Accepted Solution

Accepted Solutions

Lucien Avramov
Level 10
Level 10

Smart Call Home should be disabled by default.

The global config command 'service call-home' enables it. It's available from 12.2(33)SXH

No service call-home will disable it, however the actual call-home block cannot be removed from the configuration.

Here is a good call home configuration link:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/con

figuration/guide/callhome.html#wp1119728

View solution in original post

8 Replies 8

Lucien Avramov
Level 10
Level 10

Smart Call Home should be disabled by default.

The global config command 'service call-home' enables it. It's available from 12.2(33)SXH

No service call-home will disable it, however the actual call-home block cannot be removed from the configuration.

Here is a good call home configuration link:

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/con

figuration/guide/callhome.html#wp1119728

Hello,

Thank you very much for your reply.

I understand it.

Thanks and regards,

Hi Snakayama,

How u removed the Cisco Call Home configuration in the NVRAM..

I tried but only the service was disabled..

Let me Know ..

Thnks&Rgds

Senthil

Hi Senthil,

I could not remove Call Home setting so Call Home setting is still existing in the NVRAM ...

Regards,

Shinichi

Hi there,

You can remove the whole config and block from call-home with command: "clear config call-home"

Cheers

Hi, right on this platform, or you saw/managed somewhere else? Got inspired to try on ISRv image, but no such option..

Hello,

 

did you actually try your suggestion? Clear config is usually an ASA thing.

 

Take care…

 

The "no call-home" command in global config should take the call-home information off on the configuration.

Review Cisco Networking for a $25 gift card