cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
200
Views
0
Helpful
3
Replies
Highlighted
Beginner

Can i run EIGRP on C2960X-48FPS-L

Hi guys,

 

I have C2960X-48FPS-L (Layer 2) switch which is connected to its up-link CISCO1921/K9 (Layer 3)

 

At present 2960X is running layer 2 only and i want to run EIGRP on it.

I tried to enable "ip routing" on it and it does work however EIGRP it will not take EIGRP.

The IOS that it running on is "c2960x-universalk9-mz.152-4.E"

 

Please suggest if it is possible to run EIGRP on it

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Community Legend

Re: Can i run EIGRP on C2960X-48FPS-L

As far as I'm aware, no.

View solution in original post

3 REPLIES 3
Highlighted
Hall of Fame Community Legend

Re: Can i run EIGRP on C2960X-48FPS-L

As far as I'm aware, no.

View solution in original post

Highlighted
Beginner

Re: Can i run EIGRP on C2960X-48FPS-L

i see there is an IOS on cisco.com "c2960x-universalk9-mz.152-7.E0a.bin". So, even if i upgrade it to this IOS, EIGRP will not work ?

Highlighted
Hall of Fame Community Legend

Re: Can i run EIGRP on C2960X-48FPS-L

2960X is a pure Layer 2 switch. 

2960XR will supported very-limited Layer 3 functions like OSPF stub and EIGRP stub (Reference: Cisco Catalyst 2960-X Series FAQ). 

CreatePlease to create content
Content for Community-Ad