02-11-2020 04:44 PM
Hi guys,
I have C2960X-48FPS-L (Layer 2) switch which is connected to its up-link CISCO1921/K9 (Layer 3)
At present 2960X is running layer 2 only and i want to run EIGRP on it.
I tried to enable "ip routing" on it and it does work however EIGRP it will not take EIGRP.
The IOS that it running on is "c2960x-universalk9-mz.152-4.E"
Please suggest if it is possible to run EIGRP on it
Solved! Go to Solution.
02-11-2020 05:00 PM
02-11-2020 05:00 PM
02-11-2020 05:07 PM
i see there is an IOS on cisco.com "c2960x-universalk9-mz.152-7.E0a.bin". So, even if i upgrade it to this IOS, EIGRP will not work ?
02-11-2020 05:26 PM
2960X is a pure Layer 2 switch.
2960XR will supported very-limited Layer 3 functions like OSPF stub and EIGRP stub (Reference: Cisco Catalyst 2960-X Series FAQ).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: