cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
133
Views
5
Helpful
2
Replies
Highlighted
Beginner

Can I use "show int tranceiver detail " for check Fiober Optic quality ?

Hi all ,

 

I have some network issue , I am focusing at fiber optic  butt the contractor don't have any test report

Can I check the fiber optic quality (loss)  by use command  "show int tranceiver detail"   

Is the result of this command can grantee  the cable quality ?

Switch shown rx power  -10dbi    <<<--- not over standard

2 REPLIES 2
Highlighted
VIP Expert

it all depends on the optic, some optic support some dont, it can only give you power levels it will not give any indication what network issues.

 

what kind of network issue you are facing, ? post more information and what device / IOS / logs ? interface drops ?

 



BB


*** Rate All Helpful Responses ***

Highlighted
VIP Expert

Hello,

 

the command works on DOM (Digital Optical Monitoring) modules only.

 

If you type:

 

Switch#show interfaces GigabitEthernet0/2 transceiver detail

 

and get the result below:

 

--> Diagnostic Monitoring Data is not available

 

that means that you have a non-DOM module.

Content for Community-Ad