Can NAT port forwardign work with HSR

[teejay1719]

Hey guys, so i have HSRP configured on two routers and its working just fine, the thing is the two routers are connected to a switch and i have two pcs connected (Pcs running PBX) to the switch. I want to configure NAT portforwarding so that when the softphones that are on the other end of the network try and register to a PBX it uses the Virtual HSRP address, and then NAT sees the address being called s it then forwards it to a specific IP adddress? Is that even possible?

[Vasilii Mikhailovskii]

Hello.

From the diagram it's not clear why do you need NAT into HSRP address!

If you use static NAT no both of the devices into single IP-address (not equal to HSRP or any real IP-address assigned); this would work... at the same time each HSRP switchover would result in session loss.

[teejay1719]

I needed it for the PBX to connect to. Its very long to explain but its ok! Thank you for your reply, i tried the Nat with hsrp and it didnt work :S but its fine, im moving on to the next step haha