Re: Can not config stack on switch 2960X (2960X-24TS-L )
Your post doesn't tell us anything other then your trying to connect two switches into a stack, are these two standalone devices currently in production or are they new and you are trying to establish a stack for the first time?
Below is a basic procedure to join two new standalone switches to form a two switch stack
Note: Make sure both switches have the same ios/feature set and running image other then LAN lite!
1) Power up both switches standalone ( not connect) 2) On your switch you wish to be the master apply the following:
Master Switch 1
conf t switch 1 priority 15 switch 2 provison WS-C2960X-24TS-L end wr
Secondary Switch 2 conf t switch 1 renumber 2 switch 2 priority 13 end wr
3) Power down both switches 4) Connect the switches together via their flex stack cables 5) Power up switch 1 ...wait about 30 -40 seconds then power up switch 2
If all is well then the two switches will become stacked one the election process has completed and the switches have come online.
kind regards Paul
Please don't forget to rate any posts that have been helpful.
Let's clarify Spanning Tree Protocol, because it can be confusing.
I’m going to make this as painless as possible in the short beginning of this post, but details will follow for the rest that are curious in nature.
DOMINO168.NET BANDAR JUDI POKER ONLINE TERPERCAYA DI INDONESIADomino168.net merupakan situs agen bandarq, bandarkiu, agen bandarq, bandar66, bandar qq online terbaik,agen judi domino terpercaya. Connection alternatif bandarq, Daftar bandarkiu online terpe...
i have one switch and two ports for two dirrent network they is ring both port in same vlan configuration, i want solution if one port down then autometic traafic gone from 2nd port it is possible? Note: switch1 in 2 ethernet port avaibal...
How to upgrade Cisco IOS from Serial Port
In this topic, i will show how to upgrade Cisco IOS from the Serial Port using a console cable and Hyper Terminal without network connectivity (that would be needed for TFTP, in example). We will be using a 2960X...