I have a new 881 router and am simply trying to change the ip address from the default 10.10.10.1 to 192.168.15.1
I tried doing this both in the CCP Express app loaded on the router, and also using the desktop CCP client. I can change other parameters without any problems, but when I change the ip address of the vlan the program hangs (as expected since the ip address should be changing). I then try to open it back up and reconnect but get no response from the router.
I can ping it no problem, and the http server is running according to the serial terminal.
Check to see if there is an ACL limiting the addresses that can access the router for management. I remember some versions that included the 10.x.x.x management IP also included an ACL to limit connections to that subnet also.
The OSPF Type-2 LSA is one of the misunderstanding LSA among all the popular LSAs in OSPF , most people learns that this kind of LSA (Type-2) is generated by DR the Designated Router in a broadcast segment, for example when two or more than two routers ar...
Table of Contents
RADIUS has been the de-facto protocol for Remote Access Authentication for decades. RADIUS/UDP as defined by RFC 2865 has traditionally used MD5 for authentication and integrity. Unfortunately, successful attacks ...
Since 2008, the ASR 1000 platforms have dramatically changed the WAN edge router’s capabilities. With its very own QuantumFlow Processor (QFP) innovation, the data plane was powered to offer advanced scalable services along with high performance. Fast for...
Traditionally Cisco has used several different methods for storing passwords and keys in IOS. The older methods are Type 5 (MD5 hash) & Type7 (Vigenere obfuscation). We enabled Type 7 encryption with the CLI service password-encryption...
AI spoofing detection is a feature in AI Endpoint Analytics released in Cisco DNA Center v188.8.131.52, that identifies endp...