02-20-2014 10:20 PM - edited 03-07-2019 06:20 PM
i have 2 routers connected as point to point, A<->B. from A i can ping to B loopback ip address and vice versa. But i can't telnet from A to B using B loopback ip address, but i can telnet to B using B interface ip addresss which is connected to A.
02-20-2014 10:34 PM
Hi,
Do you have a access-class on your vty config?
Sent from Cisco Technical Support iPad App
02-23-2014 05:54 PM
no, no access-class under line vty. when i show ip route i did received the loopback ip address via ospf...even from A telnet to B using souce interface also failed to telnet.
02-23-2014 11:35 PM
Hi
You may try to login to either RouterA or RouterB and then telnet on the router itself for testing. Just want to make sure that RouterA or RouterB can be telneted.
Thanks
02-24-2014 06:03 PM
from RouterA telnet to RouterB (loopback ip)-->failed
from RouterA telnet to RouterB (interface ip)-->passed
from RouterB telnet to RouterA (loopback ip)-->failed
from RouterB telnet to RouterA (interface ip)-->failed
03-31-2020 08:57 AM
03-31-2020 01:03 PM
There was never enough information in the original discussion to be able to identify the cause of the problem. And there is not enough information in your description for us to be able to identify the cause of your problem. A good place to start would be to post the configuration of the router.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide