07-30-2014 12:57 AM - edited 03-07-2019 08:13 PM
Hello.
I want to VSS the C4500X-32 and C4500X-16 but after configuring and rebooting the standby switch show the message:
*Jul 30 00:27:22.363: %C4K_REDUNDANCY-2-INCOMPATIBLE_SUPERVISORS: STANDBY:Active and Standby supervisor types are not compatible. Autoboot on the Standby supervisor will be disabled and the standby supervisor is returned to ROMMON.Early Notification of a Critical job [iosd] exiting abnormally! Initiating cleanup sequence.
Is it normal?
Thanks.
07-30-2014 05:47 PM
Hi,
On 4500X in order to have VSS capability, the minimum software requirement is Cisco IOS XE Software Release 3.4.0SG. Please make sure that the 2 4500 have the same IOS-XE version on that release.
Hope this helps.
07-31-2014 12:06 AM
Hi,
Hardware Requirement:
VSS is network system virtualization technology that pools Two symmetric Cisco Catalyst 4500E chassis or two Catalyst 4500X-16 Series Switches or two Catalyst 4500X-32 Series Switches into one virtual switch
Software Requirement:
Cisco Release IOS XE 3.4.0SG and later releases support VSS
Regards,
Aru
*** Please rate if the post useful ***
09-21-2022 07:35 PM - edited 09-21-2022 07:36 PM
I agree with Arumugam.
I recently tried to do a VSS with two clients and they had two asymmetric 4500Xs:
1x4500X-16 and 1x4500X-32
And I confirm that it is not possible to build a VSS with different hardware characteristics on both 4500X switches. So, as Arumugam mentions, "THE TWO 4500X SWITCHES MUST BE THE SAME IN HARDWARE (number of interfaces, model and software).
Example.:
4500X-16P + 4500X-16P
4500X-32P + 4500X-32P
4500X-16P-C4KX-NM-8 + 4500X-16P-C4KX-NM-8
4500X-32P-C4KX-NM-8 + 4500X-32P-C4KX-NM-8
**C4KX-NM-8 is an expansion module and must be on both switches too.
Regards.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide