08-30-2021 01:47 AM
how we can configure a new SVI on the standby VSS switch, so then can make HSRP between them?
Solved! Go to Solution.
09-01-2021 01:12 AM
Thanks All,
If the VSS is configured then we can't configure HSRP between Standby VSS and Active VSS
08-30-2021 02:13 AM
The VSS Switch is seen as one logical switch, I am not sure how you would configure HSRP between them. Unless you have a split brain senario?
08-30-2021 03:44 AM
thank you
08-30-2021 02:41 AM
Hello @Sudqi ,
VSS builds a single logical entity and actually eliminates the need of HSRP on each SVI.,
with VSS you define the SVI on the current master , the current master supervisor is the only one to speak with outside world unless the VSS link is broken and no Dual ACtive Detection link is implemented.
You should be fine with a dual active detection dedicated link and method for example using BFD or Fast hellos
The SVI will never be active on the standby supervisor until it moved to master state taking over.
in case of failure of the VSS link/port channel the standby sup will check the DAD link if it reiceves messages from the master sup it will stay in standby state (disabling the data links on the chassis) if even the DAD link does not receive messages the standby SUP can safely assume the active sup has troubles or it has been powered and it will move to active state.
Hope to help
Giuseppe
08-30-2021 03:45 AM
Tnanks for your replay
so if I should configure HSRP, this should be before adding a VSS configuration between them,
is there a method to do the HSRP even VSS was configured?
Thank You
08-30-2021 04:23 AM
Hi,
I don't think it is recommended to do any configuration before the VSS, and HSRP does not do anything for you when you are running VSS.
If you have another router you want to take over the Default Gateway function if the entire VSS Stack goes down, then that is possible with HSRP.
There is nothing stopping you from configuring HSRP on a VSS setup, but as the VSS stack is only seen as one switch you would not have a secondary HSRP peer.
08-30-2021 04:43 AM
Thank You
09-01-2021 01:12 AM
Thanks All,
If the VSS is configured then we can't configure HSRP between Standby VSS and Active VSS
09-01-2021 01:20 AM
Hello @Sudqi ,
>> If the VSS is configured then we can't configure HSRP between Standby VSS and Active VSS
we can't configure it , but you don't need it as the redundancy service provided by HSRP (FHRP) is already provided by VSS technology
Hope to help
Giuseppe
09-01-2021 01:26 AM
thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide