Cannot access switch via new management IP address

[rmiller]

I am moving my switches to a management VLAN. I have a Catalyst 2950G-24 and after changing the Management VLAN I cannot access the switch on either the original IP or the new management IP and cannot ping either address. The management VLAN shows as active with the proper IP address in the IP address interface configuration. I can still access it through the associated cluster. What am I doing wrong?

[schaef350 · Accepted solution]

Verify you have the default gateways settings configured correctly.  

If that doesn't do it post your config and I can have a look.

[rmiller]

---

@schaef350 wrote:

Verify you have the default gateways settings configured correctly.  

If that doesn't do it post your config and I can have a look.

---

That was it -- I didn't realize the default gateway had to be on the same VLAN. Thanks!

[paul driver]

Hello

Please review this old post and see if it would be applicable to you:

Here

res
Paul