cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
355
Views
15
Helpful
7
Replies
Highlighted
Beginner

Cannot Telnet or Ping Switches

Hello everyone

 

I have a few issues which hopefully i can get some help on

 

I am trying to ping/telnet onto each switch from the management laptop but i cannot do either

 

I can ping between the VLAN hosts and servers and switches can ping each other.

 

The subnet is 172.168.0.0/26 255.255.255.192

 

I've most likely missed or misconfigured something, i have the flu so brain is a bit fried.

 

Will post more info if requested

 

Thanks all

 

 

 

 

 

2 ACCEPTED SOLUTIONS

Accepted Solutions
Rising star

Re: Cannot Telnet or Ping Switches

Dear Scott1sh,
I was check your configurations and in your switch configuration you have a command: switchport trunk native vlan 99, remove it and will works fine.

In your topology.jpg, the connection between swtch1 and r0, interface on R0 has interface in shutdown mode. (turn on interface, please.)

Jaderson Pessoa
*** Rate All Helpful Responses ***
Rising star

Re: Cannot Telnet or Ping Switches

Dear Scott1sh,
Check it, please.

ON R0 Fa0/1: 172.168.2.65
Internet Port Wireless Router - 172.168.2.126 > change port from INTERNET PORT to LAN PORT.
and all will works fine.
Jaderson Pessoa
*** Rate All Helpful Responses ***
7 REPLIES 7
Rising star

Re: Cannot Telnet or Ping Switches

Dear Scott1sh,
I was check your configurations and in your switch configuration you have a command: switchport trunk native vlan 99, remove it and will works fine.

In your topology.jpg, the connection between swtch1 and r0, interface on R0 has interface in shutdown mode. (turn on interface, please.)

Jaderson Pessoa
*** Rate All Helpful Responses ***
Beginner

Re: Cannot Telnet or Ping Switches

Hi Jaderson Pessoa

Thank you very much i can now ping between the switches, router, servers and PC

However i am still unable to ping from the laptop which is on a different network or telnet remotely

The wireless router is to be configured to use DHCP server with 192.168.5.0/24 addressing

 

The Non-vlan network is to be 1st and last host of subnet 9 (172.168.2.64-172.168.2.127)

So i could be wrong but

Router 0 = Fa0/1 = 172.168.1.2.66

Internet Port Wireless Router - 172.168.2.126

 

I have attached the router configuration and the current topology

 

I know PT can be funny with sending ICMP packets through wireless routers.

 

 

Rising star

Re: Cannot Telnet or Ping Switches

Dear Scott1sh,
Check it, please.

ON R0 Fa0/1: 172.168.2.65
Internet Port Wireless Router - 172.168.2.126 > change port from INTERNET PORT to LAN PORT.
and all will works fine.
Jaderson Pessoa
*** Rate All Helpful Responses ***
Beginner

Re: Cannot Telnet or Ping Switches

Got all working now thank you very much for the help

Rising star

Re: Cannot Telnet or Ping Switches

Great.. good lucky =)
Jaderson Pessoa
*** Rate All Helpful Responses ***
Beginner

Re: Cannot Telnet or Ping Switches

Duplicate reply

Rising star

Re: Cannot Telnet or Ping Switches

please, if possible, vote as helpful too. thanks
Jaderson Pessoa
*** Rate All Helpful Responses ***
CreatePlease to create content
Content for Community-Ad
ask the Expert- Cisco's Branch Routing Portfolio