08-22-2011 05:00 AM - edited 03-07-2019 01:48 AM
Hi all,
I needed to upload new code to my catalyst 4948-10GE using X-modem and changed confreg from ROMMON as I usually do.
Now the speed is set to 56700 bauds, I can see the initial boot on my screen using putty or hyperterm but I can't type anything.
This never happened before. Is there anything I can do here?
Thanks,
Tom
Solved! Go to Solution.
08-22-2011 05:10 AM
At such high speeds, it can be a cable problem or output level too low from the DTE u are using.
regards,
Leo
08-22-2011 05:10 AM
At such high speeds, it can be a cable problem or output level too low from the DTE u are using.
regards,
Leo
08-22-2011 05:19 AM
Thanks for the advice ! I changed to a USB to serial converter hoping for the output level to be higher and worked.
Never knew the DTE output level was something to consider in these scenarios.
Tom
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide