Cant access the web camera from outside

[Arsen Gharibyan]

hello everyone

im using the ASA 5510 for routing

i just added webcam and cant get it working from outside

i have a static nat from outside to inside

and access list allowing from outside

se attached pictures

[cadet alain]

Hi,

I'm not too much fan of the GUI but it seems you should inverse the source and destination interface in your NAT command.

Regards

Alain

Don't forget to rate helpful posts.

[Arsen Gharibyan]

Hi , I did actually it ddnt work  but anywayit has both way nat option checked so in my opinion it should wokr even is it sais Inside- outside

what about my border router (time warner)  i think port 80 needs to be forwarded to somewere

any other ideas ?

Arsen Gharibyan

Network Engineer

http://www.neocomp.com

[ALIAOF_ · Accepted solution]

Is your ASA's outside interface directly connected out to the Internet and configured with a public IP or is it sitting behind the ISP router with the private IP?  Also what code are you running on that ASA 8.3+ or below?  Like the previous poster mentioned I'm not a fan of GUI so can you paste your configuration from the CLI?  Generally you would do something like this eg;

Camera IP: 192.168.1.10

Public IP: 1.1.1.1

object network obj-192.168.1.10

host 192.168.1.10

exit

object netowrk obj-1.1.1.1

host 1.1.1.1

exit

object service CAMERA_HTTP

service tcp source eq 80

exit

nat (inside, outside) static obj-192.168.1.10 obj-1.1.1.1 service CAMERA_HTTP CAMERA_HTTP

And for the ACL:

access-list outside_acl_in extended permit tcp any gt 1024 host 192.168.1.10 eq 80

Keep in mind if you are forwarding port 80 to something else on that public IP there will be a conflict so you'll need to pick a public IP that free for port 80.

[Arsen Gharibyan]

Thank you for your reply the issue was in static route on ASA

asa cant get to the appropriate vlan

192.168.10.0 255.255.255.255

changed to 192.168.10.0 255.255.255.0

and it worked