11-09-2011 08:45 AM - edited 03-07-2019 03:17 AM
Hi,
I just looked all ten ports on SUP in slots 5 and 6 and I can see that Ten 5/3, Ten 5/4, Ten 6/3 and Ten 6/4 are inactive. I am not sure why and is there some restriction or should I add to the configuration?
Thanks.
11-09-2011 09:02 AM
Hi,
Are you sups configured for redundancy (SSO)?
what is the output of "sh redu"?
HTH
11-09-2011 09:14 AM
It is SSO
11-09-2011 09:19 AM
So, when connecting these 10Gig interfaces, do you see a link light?
11-09-2011 09:32 AM
No link light. Show interface command shows that ports are inactive. When I plug the same SFP and patch cable into Ten 5/1 or 5/2 it works. Only ports 5/3, 5/4, 6/3 and 6/4 are affected.
11-09-2011 09:33 AM
Just to add, software is IOS-XE 3.2.0
11-09-2011 11:17 AM
What is your license level?
11-09-2011 11:19 AM
entservices
11-09-2011 11:29 AM
from the config guide:
When you use WS-X45-SUP7-E in RPR or SSO mode, only the first two uplinks on each supervisor engine are available. The second two uplinks are unavailable.
11-09-2011 11:36 AM
Thanks.
I found that too, I was just not sure if there is anything that can be done to make them active
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: