And I still have a few questions. The use of MQC-like language for Queuing is fairly understandable as it is similar to Cat 4500 with Sup6/7. But where I am still a little confused is Ingress classification and marking.
For example, if I have a server or an end user directly attached to a 6848 port, and I want to classify inbound traffic using ACLs, class-maps and a policy-map, do I attach both a lan-queuing service policy AND an input service policy?
service-policy input qos-ACCESS
service-policy type lan-queuing input p_map_2q8t
service-policy type lan-queuing output p_map_1p3q8t
Re: Cat 6500 Sup 2T and 6848 line card QoS question
Not sure if you were able to do the above successfully. When I apply an input classification/marking policy, and set the dscp values of the incoming traffic, I dont see the DSCP getting applied at all.
Did you have to do anything unique to make this work?
1. Log into CLI of DNAC:
ssh maglev@< DNAC appliance IP> -p 2222
2. Run this curl command to get token to get member id:
curl -X POST -u admin:<admin user password> -H -V https://<CLUSTER-IP>/api/system/v1/identitymgmt/token
Enterprise Switching Business Unit is glad to announce Beta release 16.12.2 for all Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms. This release is made available to allow users to test, evaluate and share fee...
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...
Do you currently have hands-on networking experience? If you do, we'd love to hear from you!
Your feedback will be reviewed and analyzed by our team to directly influence a networking management and monitoring product.
Take the 20-min or les...