01-12-2011 08:02 AM - edited 03-06-2019 02:57 PM
'Hello,
I've a problem with RPS on Cisco Cat2960. Since the switch has power loss, the yellow LED blinks on RPS status.
Because the switch is obstructed in another building I will reset the RPS status via IOS. Is it possible? The power supply is connected through the switch and RPS.
Kind regards
01-12-2011 08:21 AM
I'm afraid you can't do it with the 2960. You need at least the E series switches to do that.
Hope it helps.
01-12-2011 09:01 AM
I use the Cat 2960 PoE Series. Is there no other way?
How is the CLI?
I want to try this..
Thanks...
01-12-2011 09:06 AM
There is no way in the 2960 series. It just doesn't support it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: