Hey, so I have been trying to figure out how to configure Radius over TLS on the CAT9300 device and get a Wire shark capture showing that it is working. On my device I have configured it just like the Cisco Website says to configure it:
Device(config-radius-server)# tls connectiontimeout 10
Device(config-radius-server)# tls idletimeout 5
Device(config-radius-server)# tls retries 15
Device(config-radius-server)# tls ip radius source-interface GigabitEthernet 1/0/1
Device(config-radius-server)# tls ip vrf forwarding table-1
Device(config-radius-server)# tls port 10
Device(config-radius-server)# tls trustpoint
Device(config-radius-server)# tls trustpoint client TP-self-signed-721943660
Device(config-radius-server)# tls trustpoint server isetp
I have radius working perfectly on the device, but I have never done Radius over TLS. For the Final two configurations the client trustpoint is by default on the CAT9300, but I believe that what I am missing is the servers trustpoint. Can someone point me to how I would figure this out.
