11-27-2020 03:22 PM
Hi
I use SG500 in stack mode with agregation for host servers between two nodes switches. Working fine. Do you know if this topology of LAG is supported on Catalyst 1000 cluster ?
Thanks
11-27-2020 04:48 PM
Hi,
Can you post your config? For LAG, you need a minimum of 2 1Gig or 10Gig interfaces in a bundle. You can use mode "On" LACP.
HTH
11-27-2020 05:19 PM
Hi,
I don’t have any config. I just want to know if Catalyst 1000 in stack mode support full mesh LAG like SG500 or SG350x stack.
Thanks
11-27-2020 06:47 PM
Hi,
Should not be an issue as both platforms support LAG.
https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/350xg/admin_guide/AG_Tesla_350_550.pdf
HTH
11-30-2020 07:09 AM
Actually We use this configuration on SG500 stack and works very good. We just want to know of this setup is supported on Catalyst 1000.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide