cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
416
Views
0
Helpful
6
Replies
FayasSalam95
Beginner

Catalyst 2960X POE Power Issue

Hii Guys ,

I went to a site where i am having a Catalyst 2960X FPD L model switch.When i am connecting the phone to the 2 nd port of the switch its not getting POE .But with same phone and same cable when i connect to port 1 ,I am getting POE.

Checked "show inline power" still there is power left in the switch .

Please some one could tell me what will be issue ?

6 REPLIES 6
Leo Laohoo
VIP Community Legend

Faulty cable or faulty phone.

It cant be the case as i am connecting to the 1st port ,The phone is taking POE .

Post the complete output to the following commands: 

  1. sh version
  2. sh post
  3. sh interface Gi 1/0/2
Kasun Bandara
Collaborator

Hi,

 

if you have any other PoE device, try to connect that in the same way and verify that 2nd port is not powering up and 1st port is powering without issues. also check with other ports in switch too. sometimes, port may be faulty.

 

rate this and mark as answer if this resolved your concern

Please rate this and mask as answer, if this resolved your issue
Good luck
KB

How can we confirm like that is a port failure?Could you give like a debug command or something.

FayasSalam95
Beginner

Also Cisco 2960X is having all the ports POE right ?