Catalyst 2960X POE Power Issue

[FayasSalam95]

Hii Guys ,

I went to a site where i am having a Catalyst 2960X FPD L model switch.When i am connecting the phone to the 2 nd port of the switch its not getting POE .But with same phone and same cable when i connect to port 1 ,I am getting POE.

Checked "show inline power" still there is power left in the switch .

Please some one could tell me what will be issue ?

[Leo Laohoo]

Faulty cable or faulty phone.

[FayasSalam95]

It cant be the case as i am connecting to the 1st port ,The phone is taking POE .

[Leo Laohoo]

Post the complete output to the following commands: 

1. sh version
2. sh post
3. sh interface Gi 1/0/2

[Kasun Bandara]

Hi,

if you have any other PoE device, try to connect that in the same way and verify that 2nd port is not powering up and 1st port is powering without issues. also check with other ports in switch too. sometimes, port may be faulty.

rate this and mark as answer if this resolved your concern

[FayasSalam95]

How can we confirm like that is a port failure?Could you give like a debug command or something.

[FayasSalam95]

Also Cisco 2960X is having all the ports POE right ?