04-15-2013 01:37 PM - edited 03-07-2019 12:49 PM
I have installed a Catalyst 2960-S and a 3750-X-12S and I am trying to setup a VLAN 51 for some VoIP phones. I have added the VLAN as an interface on both switches, but the 3750 is not showing VLAN 51 as active when i do a show vlan. Also, it omitts showing Gi1/0/1 & Gi1/0/3 which are uplinks to 2960-S switches plugged in and working on VLAN1.
Catalyst3750SFP#show vlan
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active Gi1/0/2, Gi1/0/4, Gi1/0/5
Gi1/0/6, Gi1/0/7, Gi1/0/8
Gi1/0/9, Gi1/0/10, Gi1/0/11
Gi1/0/12
1002 fddi-default act/unsup
1003 token-ring-default act/unsup
1004 fddinet-default act/unsup
1005 trnet-default act/unsup
VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
1 enet 100001 1500 - - - - - 0 0
1002 fddi 101002 1500 - - - - - 0 0
1003 tr 101003 1500 - - - - - 0 0
1004 fdnet 101004 1500 - - - ieee - 0 0
1005 trnet 101005 1500 - - - ibm - 0 0
Remote SPAN VLANs
------------------------------------------------------------------------------
Primary Secondary Type Ports
------- --------- ----------------- ------------------------------------------
3750-X Config:
Catalyst3750SFP#show run
Building configuration...
Current configuration : 4862 bytes
!
! Last configuration change at 00:06:20 UTC Mon Mar 1 1993 by scstech
!
version 12.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Catalyst3750SFP
!
boot-start-marker
boot-end-marker
!
!
aaa new-model
!
!
aaa authentication login default local
!
!
!
!
!
aaa session-id common
switch 1 provision ws-c3750x-12s
system mtu routing 1500
!
!
!
mls qos
!
crypto pki trustpoint TP-self-signed-296880768
enrollment selfsigned
subject-name cn=IOS-Self-Signed-Certificate-296880768
revocation-check none
rsakeypair TP-self-signed-296880768
!
!
spanning-tree mode pvst
spanning-tree extend system-id
!
!
!
!
vlan internal allocation policy ascending
!
ip ssh version 2
!
!
!
!
!
interface FastEthernet0
no ip address
!
interface GigabitEthernet1/0/1
switchport trunk encapsulation dot1q
switchport mode dynamic desirable
priority-queue out
mls qos trust cos
--------------------Omitted-----------------------------
interface GigabitEthernet1/0/12
switchport trunk encapsulation dot1q
switchport mode dynamic desirable
priority-queue out
mls qos trust cos
!
interface Vlan1
description Default
ip address 192.168.4.200 255.255.255.0
!
interface Vlan51
description VoIP51
no ip address
!
ip http server
ip http secure-server
!
ip route 0.0.0.0 0.0.0.0 192.168.4.1
!
logging esm config
!
!
!
!
line con 0
line vty 5 15
!
end
2960-S
EntDr_IDF5#show vlan
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active Fa0/2, Fa0/3, Fa0/4, Fa0/5
Fa0/6, Fa0/8, Fa0/9, Fa0/10
Fa0/12, Fa0/13, Fa0/14, Fa0/16
Fa0/17, Fa0/18, Fa0/19, Fa0/20
Fa0/21, Fa0/22, Fa0/23, Fa0/24
Gi0/2
51 VLAN0051 active
1002 fddi-default act/unsup
1003 token-ring-default act/unsup
1004 fddinet-default act/unsup
1005 trnet-default act/unsup
VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
1 enet 100001 1500 - - - - - 0 0
51 enet 100051 1500 - - - - - 0 0
1002 fddi 101002 1500 - - - - - 0 0
1003 tr 101003 1500 - - - - - 0 0
1004 fdnet 101004 1500 - - - ieee - 0 0
1005 trnet 101005 1500 - - - ibm - 0 0
Primary Secondary Type Ports
------- --------- ----------------- ------------------------------------------
2960-S config:
EntDr_IDF5#show run
Building configuration...
Current configuration : 4711 bytes
!
! Last configuration change at 02:20:17 UTC Mon Mar 1 1993
!
version 15.0
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
!
hostname EntDr_IDF5
!
boot-start-marker
boot-end-marker
!
!
aaa new-model
!
!
aaa authentication login default local
!
!
!
!
!
!
aaa session-id common
system mtu routing 1500
!
!
!
mls qos srr-queue output cos-map queue 1 threshold 3 5
mls qos srr-queue output cos-map queue 2 threshold 1 2 4
mls qos srr-queue output cos-map queue 2 threshold 2 3
mls qos srr-queue output cos-map queue 2 threshold 3 6 7
mls qos srr-queue output cos-map queue 3 threshold 3 0
mls qos srr-queue output cos-map queue 4 threshold 3 1
mls qos
!
crypto pki trustpoint TP-self-signed-2966539904
enrollment selfsigned
subject-name cn=IOS-Self-Signed-Certificate-2966539904
revocation-check none
rsakeypair TP-self-signed-2966539904
!
!
!
spanning-tree mode pvst
spanning-tree extend system-id
!
vlan internal allocation policy ascending
!
ip ssh version 2
!
!
!
!
interface FastEthernet0/1
switchport mode trunk
mls qos trust cos
----------------------------Omitted-----------------------------------
!
interface FastEthernet0/24
switchport mode trunk
mls qos trust cos
!
interface GigabitEthernet0/1
switchport mode trunk
priority-queue out
mls qos trust cos
!
interface GigabitEthernet0/2
switchport mode trunk
priority-queue out
mls qos trust cos
!
interface Vlan1
ip address 192.168.4.201 255.255.255.0
no ip route-cache
!
interface Vlan51
no ip address
no ip route-cache
!
ip http server
ip http secure-server
!
!
!
!
line con 0
line vty 5 15
!
end
04-15-2013 02:07 PM
Hello
Try this-
2960
Conf t
No int vlan 51
Vlan 50
Exit
Ip default-gateway 192.168.4.200
assign an access port to vlan 51
Int x/x
Switchport access vlan 51
3750
Config t
Vlan 51
Exit
int vlan 51
IP address x.x.x.x y.y.y.y
Ip routing
Sent from Cisco Technical Support iPad App
04-15-2013 10:57 PM
Make sure you are adding the vlan as well, not just creating a SVI, also ensure they are allowed on your trunk links
Sent from Cisco Technical Support iPad App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: