cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
140
Views
0
Helpful
1
Replies

Catalyst 4507R Issue

jorgeanta
Beginner
Beginner

Netpro's:

I have two 4507R with redundant Supervisor V 10G cards, both switches are linked with an etherchannel.

This strange issue we are experiencing consists of one of our switches getting "frezzed", you can access it via local console, all basic processes seem to be running ok (cdp, stp, etc), interfaces are linked up, but the switch is not forwarding or receiving any packets.

This failure occurs occasionaly, and we could not get any reasonable diagnostic or solution rather than rebooting it.

Your help will be trully appreciated.

Thanks!

1 Reply 1

michaelchoo
Beginner
Beginner

Your set up sounds simple enough. Are those switches running the same IOS levels? You might want to log a case with TAC.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: