Hello I have a 4510 Switch that is used as the Core Switch for the network, there are two 4516-10GE cards. As well as four 48 port blades, I would like all four of the gigabit uplinks on each of the 4516 cards to be active. The Ten Gigabit uplinks are not in use and will not be needed.
Currently since the Switch is set for redundancy in sso mode, only 2 of the uplinks are active on each card.
We do not need redundancy in the network as each uplink goes to a different Access Switch throughout the building.
If I issue the command " no redundancy " what affect can this have on the network ??
And will this make the 2 uplinks on each card show as " down" , instead of " inactive ".
The 4516 cards are in slots 5 and 6. Slot 5 is active and slot 6 is in standby.
I also need to correct something above , I need to activate all 4 links on both 4516x cards there are 2 tengig ports on each card and 4 gigabit ports on each card, because of redundancy and both of them are Supervisor cards 1 is active one is standby only 2 links can be active. I need to activate all 4 on each. Anyone have any idea how to do that I tried following some guides on cisco but no luck.
We are building out our first few AAR polices and are running into an error message.Built Global Policy with SLA class and traffic rules for voice traffic, attached to to the sites and VPN we needed, no issue. Building a second policy for management ...
Cisco Champion Radio · S7|E45 Network Insights with AI Endpoint Analytics
Identifying who and what is on the network is a challenge for many organizations. Incomplete visibility makes it difficult to implement advanced security policies and recommendatio...
HI, In the attached diagram from cisco site if we assume R101 and R102 are two DC having a layer 2 link and both are advertising same subnet (eg. 192.168.12.0/24) to the ISP i understand by using BGP metrics we can make one DC primary and other as se...
Question I am having trouble pulling DHCP from a given network. I am fairly new at DHCP servers and I am trying to understand how IP addresses work within these servers. The objective is to give DHCP to my 6 PC's on my main network. I can either...
Hello, I was doing a packet tracer lab. Everything was fine, working, then suddenly it freezed. I closed the window. Now everytime I open this file, it freezes. I uninstalled it and reinstall, still the same. Tried with an older version, keeps crashi...