Solved: catalyst 9200 connected to C9500-16X via twinax cable

Kristiane Araujo · ‎05-20-2025

Would be possible to connect C9200L-48L-4X (C9200L - access switch) to C9500-16X using SFP-H10GB-CU3M cable DAC? I have this doubt because SFP-H10GB-CU3M is a passive twinax cable...

M02@rt37 · ‎05-20-2025

Hello @Kristiane Araujo

You can use the SFP-H10GB-CU3M DAC cable to link your C9200L to a C9500-16X, since both ends use supported Cisco DAC...

Check the compatibility here: https://tmgmatrix.cisco.com/

I check and I see it is compatible...checl also the minimum ios version if necessary.

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.

View solution in original post

M02@rt37 · ‎05-20-2025

Hello @Kristiane Araujo

You can use the SFP-H10GB-CU3M DAC cable to link your C9200L to a C9500-16X, since both ends use supported Cisco DAC...

Check the compatibility here: https://tmgmatrix.cisco.com/

I check and I see it is compatible...checl also the minimum ios version if necessary.

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.