cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

213
Views
0
Helpful
3
Replies
Beginner

Catalyst 9200 stackwise-virtual not recognized

I am new to virtual staking and am not sure what I am missing but any time I enter the command - 

Switch(config)#stackwise-virtual

I get Invalid input detected at marker.

 

Can someone tell me what I am missing?

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Advisor

Re: Catalyst 9200 stackwise-virtual not recognized

I do not believe Cat 9200 will be supporting Stackwise-virtual.

 

here is supported models. and config,

https://www.cisco.com/c/dam/en/us/products/collateral/switches/catalyst-9000/nb-06-cat-9k-stack-wp-cte-en.pdf

 

BB
*** Rate All Helpful Responses ***
3 REPLIES 3
Highlighted
VIP Advisor

Re: Catalyst 9200 stackwise-virtual not recognized

I do not believe Cat 9200 will be supporting Stackwise-virtual.

 

here is supported models. and config,

https://www.cisco.com/c/dam/en/us/products/collateral/switches/catalyst-9000/nb-06-cat-9k-stack-wp-cte-en.pdf

 

BB
*** Rate All Helpful Responses ***
Beginner

Re: Catalyst 9200 stackwise-virtual not recognized

I just contacted Cisco and that is correct. I had been given the impression that it was capable. Thanks
VIP Advisor

Re: Catalyst 9200 stackwise-virtual not recognized

Suggest always verify on cisco site before buying any equiment, if not these device can not be used for the purpose the one purchased for.

 

if this is resolved can you mark as resolved. so usefull for other community members.

 

BB
*** Rate All Helpful Responses ***
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards