01-28-2020 03:45 AM - edited 01-28-2020 03:58 AM
Hi Team,
While I was to try configuring Micro BFD using the attached template, I have faced the problem with the BFD commands in the port-channel, could you please help me how to deal with this issue.
Bellow is a command:
Admin-DC-MW(config-if)#port-channel ?
min-links Minimum number of bundled ports needed to bring up this port channel
standalone-disable Ports will go to suspended mode if peer does not respond. Use with [no] prefix for independent mode.
Admin-DC-MW(config-if)#port-channel bfd ?
% Unrecognized command
Admin-DC-MW(config-if)#port-channel bfd
^
% Invalid input detected at '^' marker.
Device information:
Version 16.12.1
C9300-48P
01-28-2020 05:23 AM
Do you have bfd-template created ?
can you post below output (if possible full configuration)
show run | in bfd-temp
show run interface port-channel X (X is where you applying this macro)
01-28-2020 09:41 AM
Admin-DC-MW(config-if)#do sh run int port-ch 11
Building configuration...
Current configuration : 225 bytes
!
interface Port-channel11
description To-BR4-Tower-MW
no switchport
ip address 192.168.56.49 255.255.255.240
ip ospf message-digest-key 1 md5 #BrMic@3
ip ospf priority 255
bfd interval 300 min_rx 300 multiplier 3
Admin-DC-MW#show running-config | i bfd
bfd-template single-hop To-BR4
01-28-2020 08:11 AM
Hi,
To configure BFD for a Portchannel, you simply go to that Portchannel interface and configure bfd.
example:
config t
inter po10
bfd interval xx (this command will enable bfd).
HTH
01-29-2020 03:49 AM - edited 01-29-2020 03:51 AM
I have tried to configure BFD using the this commands but still not showing that any BFD neighbors
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: