Catalyst 9600 UDP Helper / UDP Forwarder

[apereira3]

Prezados, boa tarde

Por favor, gostaria de uma ajuda com relação às informações abaixo sobre o switch Catalyst 9600:

. O switch Catalyst 9600 implementa a funcionalidade de UDP Helper? E também implementa a funcionalidade de UDP Forwarder? (em pesquisa não consegui identificar a diferença entre estas 2 funcionalidades)

. O switch Catalyst 9600 implementa ingress rate limiting para tráfego unicast, multicast e broadcast? Seria rate limiting e não traffic shaping.

Obrigado!

Atte.,

Allyson

[balaji.bandi]

IP directbroacast  or ip forward-protocol should support on this device.

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipapp/command/iap-cr-book/iap-i1.html

you can use QoS handbook for shaping : example

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9400/software/release/16-6/configuration_guide/qos/b_166_qos_9400_cg/b_166_qos_9400_cg_chapter_01.html

[apereira3]

Thank you @balaji.bandi !

But what about unicast/multicast/broadcast ingress rate limiting, this is possible on Catalyst 9600? You talk only about traffic shaping. 

Thanks!

[balaji.bandi]

you can do many way refer cisco documentation and steps :

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9600/software/release/16-12/configuration_guide/sec/b_1612_sec_9600_cg/configuring_port_based_traffic_control.html