CATOS command to find GBIC type

[paul.2.smith]

Could anyone tell me the CATOS command I would need to run to find out the GBIC types in the modules of a Cat4006?

It has a Supervisor Engine II WS-X4013.

I don't have access to the switch and need someone to run the command locally for me.

Thanks

[garethpeart]

Well, you could try "Show sprom <mod/port>"

That should get you the details you need. The following is the output from one of our old CATOS 6509

langonz180 (enable) sh sprom 9/1
GBIC Serial EEPROM Contents:
Common block:
Identifier : GBIC [0x01]
Connector : SC connector [0x01]
Transceiver
Speed : [0x00]
Media : [0x00]
Technology : [0x00]
Link Length : [0x02]
GE Comp Codes : [0x00]
SONET Comp Codes : [0x00]
Encoding : 8B10B [0x01]
BR, Nominal : 13x100 MHz [0x0d]
Length(9u) : 100 x 100 m [0x64]
Length(50u) : 55 x 10 m [0x37]
Length(62.5u) : 55 x 10 m
[0x37]
Length(Copper) : GBIC does not support copper cables,
or the length information must be determined from
the transceiver technology. [0x00]
Vendor Name : CISCO-AGILENT
Vendor OUI : 0x0 0x30 0xd3
Vendor PN : QFCT-5699
Vendor rev : 0000
CC_BASE : 0xc7

Extended ID Fields
Options : Loss of Signal implemented TX_FAULT signal implemented TX_DISABLE is implemented and disables the serial output
BR, max : Unspecified
BR, min : Unspecified
Vendor SN : A10030360
Date code : 021026
CC_EXT : 0x33

[Ganesh Hariharan]

Hello Paul,

You can issue 'show version' in CatOS to see what you are looking for.

This link will explain you stuffs more:

http://cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801c1e9a.shtml#catos

Hope it Helps..

-GI

Rate if it helpss

[acampbell · Accepted solution]

Hi,

When you issue "show port status" you should see as below:-

Port  Name               Status     Vlan       Level  Duplex Speed Type
----- ------------------ ---------- ---------- ------ ------ ----- ------------
 1/1                     disable    1          normal   full  1000 1000BaseSX
 1/2                     disable    1          normal   full  1000 1000BaseSX

This tell you that your ports on the supyII are 1000BaseSX = Short haul - multimode

Hope this helps

Regards

Alex

[paul.2.smith]

Thanks, that's just what I needed to find out