This is a weird issue that I have seen with servers in the past. The issue we had was we would set the interfaces to AUTO and it would not negotiate at the correct speed and duplex. To resolve the issue we had to specify the duplex and speed. Have you tried to set the interace(s) as auto instead of specifying 100/full?
Yes, we've had it configured every possible way. The interfaces also agree on the correct speed and duplex settings (also when configured auto/auto). But even then CDP will state that there's a duplex mismatch.
Cisco Champion Radio · S7|E30 Taming Your AI/ ML Workloads with Kubeflow
As organizations increasingly introduce machine learning (ML) capabilities to their existing products, their artificial intelligence (AI) projects and operations complexity g...
Cisco IOS-XE 17.3.1 – Catalyst Switching Updates
Table of Contents
Hardware Additions since IOS-XE 17.2.1
Key Summary Features
Platform and Infra Features
High Availability Features
Routing / MPLS / VPN Features
Hi Everyone,I have 2 queries1. After we configure the IPSec VPN in a Cisco Router, how do we identify and check that the traffic is flowing through the tunnel? Are there any commands and ways to find it out?2. What are some of t...
Cisco Champion Radio · S7|E29 Increase Visibility and Enhance Security with Cisco AI Endpoint Analytics
Cisco is on a journey to making networking smarter with artificial intelligence and machine learning. The latest stop in this journey, Cisco AI...