07-22-2014 02:15 AM - edited 03-07-2019 08:09 PM
Hi
I have a problem here , cdp neighbor shows the same switch as the neighbor and the real connected switchh . I know it will show only the real connected switch if i shut and no sh . What i just want know is it a symptom for something else
Dist#sh cdp neighbors Gig 10/10
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone,
D - Remote, C - CVTA, M - Two-port Mac Relay
Device ID Local Intrfce Holdtme Capability Platform Port ID
Sw1
Gig 10/10 130 S I WS-C3560- Gig 0/3
Dist
Gig 10/10 156 R S I WS-C6513 Gig 10/10
Thank you
07-22-2014 04:26 AM
I have seen this when a layer 1 device (hub) was inline somewhere between the switches.
07-22-2014 07:51 AM
After i did shut and no shut it is ok
09-17-2014 02:30 PM
HI,
Did you did shut and no shut in the interface. ?
Is it working fine.?
is it fiber connected cable connected with these devices ?
Regards,
Gurudath K S
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide