cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1242
Views
0
Helpful
2
Replies

Change config on one switch and have it apply to every switch on the network

lpescato
Level 1
Level 1

Hi Everyone,

I was wondering:

Say you wanted to add a user to your config, but you have 30 switches in your lab and only want to configure one, but have the config propogate to all the switches.

Is this possible, and if so, what is the CLI for it?

Thanks

Larry

2 Replies 2

Daniel Segovia
Level 1
Level 1

Hi Larry,

I'm not an expert in this area but here's what I have:

Switch Stacks

  • One option (if lab area allows) is physically "stacking" your switches (requires a special cable).
  • The limitations are:
    • You can only have so many in a stack (12 max I believe)
    • They will need to be stacked (and therefore, that restricts your distance to devices)
    • If this option works for you, updating one switch updates them all because they act as one logical device.
    • More on that here

SmartInstall

  • However, what I believe you might be looking for is SmartInstall.
    • This is used for zero-touch switch deployment.
    • While there are other (non-Cisco solutions), this is the one I've heard of before.

Hope that helps,

Dan

ktbyers
Level 1
Level 1

If this is a lab environment and a one-off, then a script would work (Python).  Ping me and I can possibly help create something (ktbyers at speakeasy dot net).

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: