cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
473
Views
0
Helpful
4
Replies
Highlighted
Beginner

Change PIM dr-priority

Hello,

We are planning to change the PIM dr-priority on a production vlan.  dr-priority was not set earlier hence it took the highest IP address as DR. Unfortunately highest IP address was on a backup switch vlan interface.

We would like to make the PIM DR as Main switch vlan interface by changing the dr-priority.  While making this change will it,any way disturb the production network means any outage may occur during this configuration change?

Please let me your valuable inputs.

Attached is the current DR, priority status.

Thanks 

Shibu

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

HelloYes - correctresPaul

Hello
Yes - that is correct it shouldn't be intrusive-  However as with anything I would put it pass change control prior to making any changes on your production network


res
Paul



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future

View solution in original post

4 REPLIES 4
Highlighted
VIP Mentor

Hello

Hello

It shouldn't do , As the DR is only for join messages it isnt a forwarder of MC traffic.

res
Paul



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
Highlighted
Beginner

Hello Paul,

Hello Paul,

Thanks for your reply.

"It shouldn't do , As the DR is only for join messages it isnt a forwarder of MC traffic"..   Could you please make it clear. you mean i can change it just like that. no outage?

thanks

Highlighted
VIP Mentor

HelloYes - correctresPaul

Hello
Yes - that is correct it shouldn't be intrusive-  However as with anything I would put it pass change control prior to making any changes on your production network


res
Paul



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future

View solution in original post

Highlighted
Beginner

Thanks Paul.

Thanks Paul.

Content for Community-Ad