%SFF8472-5-THRESHOLD_VIOLATION: Te2/6: Rx power high warning; Operating value: -0.0 dBm, Threshold value: -1.0 dBm.
%SFF8472-5-THRESHOLD_VIOLATION: Te3/1: Rx power high warning; Operating value: -0.9 dBm, Threshold value: -1.0 dBm.
- Is it possible to change the threshold values or disable this log messages ?
- for high power warning (not alarm!) do we need to put attenuator on the TX side or can we just ignore the message ?
for ex. in the second message I only have 0.1dB more than the warning threshold: annoyng message !